BBV BBV RX100 Guia de Instalação descarregar pdf (Página 9)

Tx1000 SeriesTelemetry Transmitter Installation Handbook Rev-01 Page 9 of 141

PATROL SETTINGS

There are two patrol commands that can be started by the BBV Tx1000. They are activated by pressing the Patrol key

and either Key 1 or Key 2. All other keys are ignored. Their function is to enable a string of presets to be selected in

turn, switching between presets after a fixed period of time (nominally 30 seconds).

Note: Once the nominal time period of 30 seconds has been altered, it cannot revert back.

These patrols can be stopped at any time by pressing any of the four arrows on the Pan and Tilt control, when the

reciever on which patrol is running is selected.

To Programme a Patrol

There is no separate patrol-programming function with the BBV Tx1000 keypad. Once a preset has been

programmed, it is automatically included in Patrols 1 and 2.

To Remove a Preset from a Patrol

1. Select the reciever on which the patrol is to run.

2. Press Program to gain access to the menu, then press 5 to remove a preset from Patrol 1 or 6 to remove from

Patrol 2, followed by the preset number to be removed.

This key sequence is illustrated below.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Sem comentários

BBV BBV RX100 Guia de Instalação Página 9