BBV BBV RX100 Guia de Instalação descarregar pdf (Página 5)

Tx1000 SeriesTelemetry Transmitter Installation Handbook Rev-01 Page 5 of 141

Camera Selection

A camera may be selected onto the controlled monitor by pressing the relevant numbered key.

Monitor Selection

The monitor key has a red LED which is lit when the keypad is controlling the second monitor output. Pressing the

monitor key toggles between the main monitor and the second monitor.

Sequence Activation

Pressing the sequence key will start the sequence on the MAIN monitor. The on-screen display changes from CAM

XX to SEQ XX to indicate that the sequence is running. To stop the sequence, select a camera on the main monitor.

Programming the Sequence Order

Holding down the sequence key causes the sequence to run through the list of inputs at the rate of one per second,

allowing the operator to quickly determine which inputs are/are not in the sequence list. While the sequence key is

held down, any camera key pressed will toggle the inclusion or exclusion of the relevant input. When delivered, all

camera inputs are inluded in the sequence.

Altering the Sequence Delay

This is achieved by pressing the Program key, to gain access to the menu. Sequence delay time may be altered using

Option 9. The on-screen prompt "Seq Delay" appears, inviting the operator to enter a number from 1 to 16 for the

following values:

5 seconds

10 seconds

15 seconds

20 seconds

25 seconds

30 seconds

35 seconds

40 seconds

45 seconds

50 seconds

55 seconds

60 seconds

65 seconds

70 seconds

75 seconds

80 seconds

After entering the delay value, the screen clears.

The Triangular-Marked Key

This key activates a relay in the base unit. Pressing the key causes changover contacts to close; releasing the key

opens one set and closes the other. This key may be used by the installer to activate a panic record facility on a VCR,

or to activate a video printer, etc. These contacts are low-voltage, low-current only.

IMPORTANT: DO NOT CONNECT THESE CONTACTS TO MAINS POTENTIALS

1 2 3 4 5 6 7 8 9 10 ... 13 14

Sem comentários

BBV BBV RX100 Guia de Instalação Página 5