BBV BBV RX100 Guia de Instalação descarregar pdf (Página 14)

Tx1000 SeriesTelemetry Transmitter Installation Handbook Rev-01 Page 14 of 141

Additional information

It is strongly recommended that this equipment is pre-built in the installer's

workshop in advance, to ensure problem-free installation at the customer's

premises.

1. The software version number is displayed for approx 2 seconds on first power up -

eg "VF"

2. The keypads should not be connected or disconnected from a "live" working unit,

as this may damage the RS232 components.

3. A new menu item "15" now appears on pressing the program key. This allows the

programming of the max camera in any system, ie

Press program

To set max cam to 3, all other camera keys are now inoperative for camera selection.

4. Alarm programming menu items appear even if no alarm option is present. These

options are inoperative unless an alarm version has been purchased, recognisable

by the THREE green connectors along the bottom edge of the case.

5. Priority control between two keypad systems

Keypad one has priority over keypad two. If keypad one is only viewing but not

operating any camera, then keypad two may move that same camera. After

movement commands on keypad one, there is a 20-second or so lock-out period

before control is given to keypad two.

1 2 ... 9 10 11 12 13 14

Sem comentários

BBV BBV RX100 Guia de Instalação Página 14